The Importance of Generator Maintenance
All mechanical equipment needs preventative and corrective maintenance, including Generators. It's just a fact of life. Which is why you should protect the equipment that protects your home and family.
Oil and filter changes, cleaning (inside and out), testing and calibration, all by a trained eye, should be a part of the annual maintenance of your generator. Failure to do so will absolutely decrease reliability and void your manufacturer warranty.
SOJI Power Solutions can handle all of your residential and commercial generator maintenance and repairs. Learn more about our comprehensive service plans below.
ANNUAL GENERATOR MAINTENANCE PLANS
Plan Details | Silver | Gold | Platinum |
|---|---|---|---|
Full Tune Up: Change Engine Oil with Synthetic, Replace Oil Filter, Replace Air Filter, if needed, Replace Spark Plugs, Check Wiring for Loose Connections/ Corrosion & Damage, Clean & Tighten Battery Terminals, Transfer Power (If ATS Accessible) for 10 Minutes, Full Service inspection | 1 | 1 | 1 |
Parts & Labor (not covered by warranty) | 5% Parts Discount | 10% Parts Discount | 15% Parts Discount |
Full Service Inspection: Check Battery Condition, Inspect/Test Fuel System, Transfer Switch, Check Engine Ignition, Check Exhaust System, Test Engine Safety Devices, Power Outage Emulation | 1 | 1 | 2 |
Battery Replacement | Included every 3 years*** | Included every 2 years*** | Included every 2 years*** |
Office Emergency Response Time | Next Business Day | Within 12 Hours | Within 6 Hours |
Fan Belt Replacement and Coolant Flush (if appliciable) | ✓ |
Preventative Maintence Annual Pricing | Silver | + Monitoring | Gold | + Monitoring | Platinum | + Monitoring |
|---|---|---|---|---|---|---|
Remote Monitoring Device (Includes Installation) | $469 (one time fee) | $469 (one time fee) | $469 (one time fee) | |||
Air Cooled <24kw | $379 | $514 | $499 | $634 | $649 | $784 |
Liquid Cooled <60kw | $569 | $704 | $739 | $874 | $959 | $1094 |
Liquid Cooled 60kw and up | $689 | $824 | $899 | $1034 | $1169 | $1304 |
STANDARD POINTS OF INSPECTION
Pre-Start Generator Checks
-
Inspect Generator Control Panel
-
Check Run History on Controller
-
Inspect Fuel Lines & Connections
-
Inspect Fuel Level
-
Inspect Oil Level & Condition
-
Inspect Leaks
-
Inspect Accessory Drive Belts
-
Inspect Hoses & Clamps
-
Inspect Coolant Level & Cap
-
Inspect Air Inlets & Clear Debris
-
Check Wiring for Loose Connections, Corrosion & Damage
-
Clean & Tighten Battery Terminals
-
Check Battery Charge State
-
Gas Pressure Test
-
Clean Exterior & Interior of Generator
Maintenance
-
Preventative Maintenance Agreements packages for the most comprehensive level of service
-
Routine maintenance services
-
Load bank services (extend the life of your generator by preventing wet-stacking)
-
Repair services from 8kW to over 2MW
-
Factory start-ups
-
Fuel Polishing
-
Remote Monitoring
-
Warranty repairs on most major brands
Service
Pre-Start Transfer Switch Checks:
-
Inspect Dead Front & Cover
-
Remove Dust. Debris & Grease
-
Check Wiring for Loose Connections, Corrosion & Damage
-
Inspect Fuses. Relays & Breakers
Tune Up (If Applicable)
-
Change Engine Oil with Synthetic
-
Replace Oil Filter
-
Replace Air Filter, if needed
-
Replace Spark Plugs
-
Check Wiring for Loose Connections. Corrosion & Damage
-
Clean & Tighten Battery Terminals
-
Transfer Power (If ATS Accessible) for 10 Minutes
Generator Operations Checks
Generator Operations Checks:
-
Check Battery Charge State
-
Check Battery Cranking Voltage
-
Gas Pressure Test
-
Check Generator Voltage, and Amperage Output
-
Check Fuel Pressure Under Load
-
Clean Exterior & Interior of Generator
-
Run 5 Minutes No Load
The Fine Print
*Points of inspection may be modified as needed for various system requirements.
** Customers outside of Bexar county will incur a trip charge, per hour of travel.
*** Service contracts must be renewed annually and consecutively to validate complementary battery replacement. If the contract has expired and/or the term has not been fulfilled from the starting date of the first contract, the customer is responsible for the full price of the replacement/service, less equipment discounts per individual contract terms, if applicable.